Skip to main content
Skip table of contents

How to manually control the Dual Channel Receiver when it is disconnected from the Genius Hub

This article gives procedures required to put the Dual Channel Receiver into Manual only control in order to give you the ability to manually control on/off state of the Dual Channel Receiver in the case the device becomes disconnected from the Genius Hub.

The Dual Channel Receiver shows a flashing red light next at the top corner.

Step-by-step guide

  1. Power off the Dual Channel Receiver
  2. Hold down both the RED and GREEN buttons together
  3. With the buttons held down, power on the device

When the Dual Channel Receiver is in Factory Mode - the buttons have the following functions:

ButtonsTop Button StateBottom Button State
REDONOFF
GREENOFFON
ZONE 1ONON
ZONE 2OFFOFF

While the Dual Channel Receiver is in Manual only control, use the ON and OFF buttons to control the relay state

To exit Manual only control, simply power cycle the device by:

  1. Power off the Dual Channel Receiver
  2. Power on the Dual Channel Receiver and this will need re-including onto the system

Using this procedure during normal operating will drastically decrease battery of devices and this is only recommended for VERY OCCASIONAL EMERGENCIES or advised by the Support team.


JavaScript errors detected

Please note, these errors can depend on your browser setup.

If this problem persists, please contact our support.